Two-Hole Punching; Troubleshooting; Maintenance And Care - LEITZ comBIND 500e Gebrauchsanweisung

Troubleshooting

Problem
Pages of bound document
do not turn with ease.
You hear an alarm sound
from the unit.
No response when
pressing the punching
button.
The fuse is blown.

Maintenance and care

• To prevent damage to the punching mechanism, empty the cuttings tray
• In case of defects: Do not attempt to repair the unit yourself. Contact the manufacturer for any required repairs.
Read guarantee declaration for further information.
• To clean the housing, unplug the unit and wipe the outside with a damp cloth. Do not use any chemicals for cleaning.
Operating method
Paper size
Punching dies
Punching depth
Punching capacity
Plastic comb size
Mains voltage
Power consumption
Net weight
Subject to technical changes without prior notice.
8

Two-hole punching

• Set the paper stop to the paper format used.
Caution! To prevent damage to the motor and punching mechanism,
0.2 mm at the same time. Also, empty the cuttings tray regularly.
• Insert the sheets into the front slot
• Press the punching button
• Remove the punched sheets.
Remedy
Set the punching depth
Empty the cuttings tray
mechanism.
Is the cuttings tray full? Is the unit properly connected to a live mains socket and
switched on ? Is the fuse
Replace fuse with same type and rating. If new fuse blows again, have the unit repaired
.
according to the comb size used.
immediately to prevent damage to the motor and punching
blown? If yes, go to next step.
regularly.
.
A4, US letter, A5
220–240 V AC, 50 Hz
450 mm x 550 mm x 170 mm
Electrical
17 kg