Quick MILL 04005 Bedienungsanleitung Seite 14

B) The machine does not dispense coffee:
- No water in the tank; restore the water level.
- The boiler was not filled.
- Overheated coffee pump, wait for thermal protector reset.
C) The machine does not dispense hot water or steam:
- No water in the tank; restore the water level.
- Overheated hot water/steam pump, wait for thermal protector reset.
- Clogged nozzles; clean steam wand nozzles.
E) Irregular coffee dispensing:
- Clean the filter found in the filter holder.
- Coffee grinding too fine or too coarse.
For all other types of defect or unspecified problem, unplug the power-supply plug, do not carry out
repairs or checks on your own and contact a qualified technical service centre.
TERMOPID functional technical specification
11.
1.1 PROGRAMMING SET-POINT OF TEMPERATURE

Press the button

When the display shows PrG, press the button

When the display shows the setpoint, set with the buttons
minimum of 85C° to a maximum of 105C°.
After 3 seconds from the last button pressing, the data are saved and the display shows the temperature.
1.2 PROGRAMMING ADJUSTMENT PARAMETERS

Switch on the machine through the main switch 1 by pressing buttons

When the display shows F.03, release the buttons.
Button slides the parameters.
Button enters the programming menu.
Inside the programming menu, the buttons
pressing, the data are saved by quitting the programming menu.
List of parameters
Parameter
F.03
and
Display
ºF Unit of measurement: degrees Fahrenheit
ºC Unit of measurement: degrees Celsius
and
and
change the data; after 3 seconds from the last button
Description
14
the desired temperature value, from a
at the same time.