ADURO H2 Bedienungsanleitung Seite 50

Important: The control handle will get warm when the Aduro H2 is being used. Please use the glove
provided when you operate the Aduro H2.
At www.adurofire.com you can find a film showing how to light your stove.
3.3.2 Lighting the fire with pellets
Push the ON/OFF button and the "On lamp" will display a constant green color. The lighting of the fire will
then start automatically and a flame should appear after approx. 6 minutes. Normal use should be achieved
after 15-20 minutes.
At a 90°C smoke temperature the stove changes to the last setting. You can change between 3 steps by
pushing 'Reset Alarm'.
Step 3 (100 % operation): 'On lamp' lights green constantly
Step 2 (50 % operation): 'On lamp' blinks quickly
Step 1 (10 % operation): 'On lamp' blinks slowly
When you want to switch of the pellet burner, push the ON/OFF button.
3.3.3 Lighting the fire with wood and pellets at the same time
Cold stove
Put the dry wood in the combustion chamber- just as if you wanted to start the stove manually as at point
3.3.1 – however, you won't need any firestarters. After this, the fire is started with pellets as in point 3.3.2. It
will be an advantage, if you start with a closed air inlet until a fire is burning in the pellet burner. After this,
you can open the air inlet for easier lighting of the firewood. When the logs have caught fire and the smoke
temperature is about 275 degrees, the pellet supply will stop automatically.
50