Battery Error Codes (Only In Combination With Power 26-104) - Torqeedo Cruise 2.0 R Bedienungsanleitung

Display Cause
E46 Battery operating tempe-
rature error
E 48 Charging temperature
error
Other error Faulty
codes
No function of No power / faulty
display

Battery error codes (only in combination with Power 26-104)

Anzeige Ursache
Battery outside temperature
E70
range during charging
Battery outside temperature
E71
range during discharging
Battery FETs outside
E72
temperature range
E73 Overcurrent during discharging
E74 Overcurrent during charging
E75 Pyro-fuse released
E76 Voltage too low
Voltage too high during
E77
charging
E78 Battery over-charged
E79 Electronic battery malfunction
E80 Deep discharge
E81 Water-sensor deployed
Disbalancing among different
E82
batteries
E83 Software version error
Number of batteries does not
E84 match enumeration process
results
E85 Disbalancing within one battery
What to do
Battery cells outside operating temperature between -20°C
and +60°C (-4°F to 140°F). The motor can be used again
when the temperature has stabilized.
Charging will continue when the cell temperature is
between 0°C and +45°C (32°F to 113°F).
Contact Torqeedo Service and notify them of the error
code.
Check power connection to motor incl. on/off switch. If
power connection is flawless, contact Torqeedo Service.
Was ist zu tun
System can be operated when battery is inside temperature
range again. Disconnect the charger for better cooling.
Switch battery OFF and ON.
System can be operated when battery is inside temperature
range again. Stop or reduce current drawn from battery for
better cooling. Switch battery OFF and ON.
System can be operated when battery is inside temperature
range again. Switch battery OFF and ON.
Remove cause for overcurrent. Switch battery OFF and ON.
Disconnect charger. Use only Torqeedo charger. Switch
battery OFF and ON.
Contact Torqeedo service.
Charge battery.
Disconnect charger. Use only Torqeedo charger. Switch
battery OFF and ON.
Disconnect charger. Use only Torqeedo charger. Switch
battery OFF and ON.
Contact Torqeedo Service.
Contact Torqeedo Service.
Ensure that the battery is dry/in a dry place. If needed clean
battery housing incl.its water detector. Switch battery OFF
and ON.
Charge all batteries individually to full.
Batteries with different software versions were connected.
Contact Torqeedo Service.
Check battery connections. The expected number of
batteries is shown in the display under the error code. Check
function of individual batteries. Potentially re-establish
communication between outboard and battery as described
under 5.3.1.1.
During the next charging process: do not disconnect charger
from the battery. Leave charger connected to the battery
after the charging process is completed for at least 24 hours.
77