Torqeedo Cruise 2.0 R Bedienungsanleitung Seite 70

Other messages:
Drive slowly: pops up when battery capacity is < 30%.
received display in second field will always indicate "remaining range at
current speed" (indication of time) and a clock symbol will be displayed.
If remaining run-time is more than 10 hours, remaining running time
will be displayed in whole hours. If it is less, remaining running time is
displayed in hours and minutes. GPS module stops signal searching after
5 minutes if no signal has been received. To activate search again, switch off the system
on "ON/OFF" button and then on again.
This symbol is displayed when tiller or remote throttle shall be brought into middle
position (stop position). Without doing so, starting will be impossible.
Is displayed in case of overtemperature of motor or batteries (operating with Power
26-104). In this case, motor will dump power independently.
Error: In case of errors, in the undermost box, "Error" symbol and an error code will be
displayed. The code will indicate the component causing the error and the error
itself. Chapter 5.3.4. describes any error codes.
In case of a drop of charge level below 30%, three beeps will be emitted (Cruise T Models
only). Signal beep is repeated in case of drop of charge level below 20% resp. 10%.
Watch the charge status while operating the motor.
70
Charging: is being displayed under charging.
GPS module integrated into battery pack is searching for satelli-
te signals for speed determination. As long as no GPS signal is