Starting Up; Mounting Of Drive To The Boat (Cruise R And Cruise T) - Torqeedo Cruise 2.0 R Bedienungsanleitung

4. Starting up

• Ensure secure foothold when fixing the outboard.
• Mount outboard first (ensure a proper foothold before) and remote
• Take care not to crush hands or fingers.

4.1 Mounting of drive to the boat (Cruise R and Cruise T)

Note: For better clarity in this chapter we will use solely drawings of Cruise R.
Instructions, however, also are relevant for Cruise T – mounting is identical.
• Please ensure that the kick lever at the transom mount is in the "Lock"
• Do not lay the cable around sharp edges.
1. Remove the parts supplied with the Cruise from the packaging.
2. Hang the drive on the transom or the motor holder of your boat and tighten the two
mounting clamps.
3. As an alternative the drive can be screwed with four screws (Ø 8 mm / 0.3 inches,
not supplied) through the holes in the clamping mechanism onto the boat's transom
mount.
56
throttle/tiller and battery afterwards.
position until the outboard is fitted onto the boat.