Starting And Stopping Recording - Tascam DR-10C Bedienungsanleitung

Whether the power is on or off, when connected, the
screen appears to allow selection
POWER/STORAGE
of bus power supply or USB connection with the
computer.
Use the . [j] and / [k] buttons to select
(highlight) the or
POWER STORAGE
bottom of the display, and press the 7'9 [ENTER]
button.
•
If is selected, power will be supplied from
POWER
the USB port and the Home Screen will open.
•
If is selected,
STORAGE USB connected
appear on the display after the unit connects to
the computer without any problems.
The unit will be shown on the computer as a USB
device named "DR-10".
Double-click the "DR-10" drive to open it and
show a list of the recording files, so you can
retrieve the desired files.
14
TASCAM DR-10C
Starting and stopping
recording
You can use a single operation to start recording
with this unit even when it is off.
item at the
8 One touch recording
When the unit is off, slide and hold the
¤ ?o — 0REC switch toward 0REC for
about one second until the
startup message appears and recording starts.
8 Ordinary recording
To start recording when the unit is on, slide the
¤ ?o — 0REC switch toward 0REC for
will
about one second.
8 Stopping recording
Slide the switch toward 0REC during recording
for about one second to stop recording.
The following information appears on the display
when stopped, when recording starts and during
recording.
Stopped
When recording
starts
Recording
1 Level meter
2 Remaining battery charge
3 Recorder operation status
4 File name
5 Elapsed recording time
TASCAM DR- 10
NOTE
• The one-second delay is intended to prevent
• Without pausing recording, a new file can be
• Set the mic input sensitivity with the
−12dB
accidental operation.
created automatically during recording when
the file size reaches 2 GB. (Track incrementing)
item on the Menu Screen so that that activity
of the level meters reaches the arrow (at −12
dB) in the illustration. (See "Menu structure" on
page 18.)
MIC GAIN