Recording; Recording Screen; About Recording Standby; Menu Structure - Tascam DR-05 Bedienungsanleitung

Recording

Recording Screen

This screen appears when recording or in recording standby.
1 Level control function status
: Level control off
: Peak reduction on
: Automatic level control on
: Limiter on
2 Plug-in power status
: Plug-in power off
: Plug-in power on
3 Pre or Auto recording function status
appears when the prerecording function is ON.
appears when the auto recording function is ON,
and the unit is recording.
4 Low cut filter on/off status
: Low cut filter off
: Low cut filter on
5 Auto tone function status
This icon shows whether the auto tone function is on or
off. (See "Using the auto tone function" in the Reference
Manual.
: Auto tone off
: Auto tone on
10
TASCAM DR-05
6 Recorder operation status
This icon shows the recorder operation status.
Indicator Meaning
Recording standby
8
Recording paused (recording standby)
9
Recording
0
7 Level meters
The input signal levels are shown.
When overdubbing, the levels of the mixed input and
playback sounds are shown.
8 File name
The file name that will automatically be given to the
recorded file is shown.
9 Recording mode
The recording file format, sampling frequency and stereo/
mono ( ST / MONO ) status are shown.
0 Elapsed recording time
The elapsed recording time of the file appears as hours:
minutes: seconds.
q Remaining recording time
The remaining recording time until the selected maximum
file size is reached is shown (in hours: minutes: seconds).
If the remaining recording time on the microSD card is
less, however, the remaining recording time on the card is
shown.
w Peak value in decibels (dB)
The peak recording level value is shown digitally.
e Input level button display
The . and / buttons are shown as a reminder that
they can be used to change the input level.

About recording standby

This unit has a recording standby function like that of a profes-
sional recorder. In recording standby mode, you can adjust the
input level, for example, and then start recording quickly.
When in recording standby, the REC indicator blinks and the
recording screen appears.

Menu structure

REC SETTING
Set the file format
FORMAT
WAV : 16bit / 24bit,
MP3 : 32 – 320k bps
Set the sampling frequency
SAMPLE
44.1k / 48k / 96k (Hz)
(96kHz for WAV only)
Set to mono or stereo
TYPE
MONO , STEREO
Set the maximum file size
SIZE
64M / 128M / 256M / 512M / 1G / 2G(B)
Turn plug-in power on/off
MIC POWER
ON , OFF
Set the low-cut filter
LOW CUT
OFF , 40Hz , 80Hz , 120Hz
Set the pre-recording function
PRE REC
ON , OFF
Set the auto tone function
AUTO TONE
OFF , HEAD , HEAD+TAIL
Set the length of the auto tone
TONE SECS
0.5SEC. , 1SEC. , 2SEC. , 3SEC.
Set the volume of the auto tone
TONE VOL
-12dB , -18dB , -24dB , -30dB , -36dB
Set the auto-recording function
AUTO REC
MODE : OFF , NEW FILE , MARK
LEVEL : -6dB , -12dB , -24dB , -48dB

Manually adjusting the input level

1.
Press the RECORD [0] button to enter recording standby.
2.
Use the . and / buttons to adjust the input level.
Meters that show the input level settings appear at the
bottom of the display.
If the input is too high, the PEAK indicator on the upper left
above the display lights just before recorded sound would
distort.
A b mark is provided at -12dB on the level meters. Set the
recording level so that level changes occur near this mark
without causing the PEAK indicator to light red.