Power Connection; Plug The Cable Into An - Bosch Indego 350 Installationsanleitung

Power connection

3
We advise powering the docking station now so when you
have finished the installation the mower will be ready to go!
Feed the power supply through
3.1
the backing cover and into the
docking station.
Put the cable through the backing cover.
Do not clip the cover yet you will do this
in step 4.9.
Ensure the power supply is
3.2
in a cool, dry environment.

Plug the cable into an

3.3
indoor power socket.
You should now see a flashing light
on the docking station.
12
Switch the Indego on.
3.4
The isolator switch is located at the back left
of the mower. Please note, if the mower is not
turned on, it will not charge. At this point,
nothing will be shown on the display.
OFF ON
Slide the mower into the
3.5
docking station for charging.
Although your Indego will have charge in the battery,
it is recommended to charge it fully before running it
for the first time.
Make sure the isolator switch is on ( | ) before placing
the Indego in the dock.
Check the indicator on the
3.6
docking station is now stable.
If the indicator does not light up check that the mains plug
of the power supply is plugged in properly and that the
mower is in the station correctly.
GB
13