Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Care; Troubleshooting - Klarstein 10030823 Handbuch

Vorschau ausblenden Andere Handbücher für 10030823:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
The cleaning of the filter mesh
The filter mesh is made of high-density stainless steel. Please do not use the corrosive detergent on it. Main-
taining the cleanliness of the filter is important to keep the cooker hood operating effectively. Please follow
the guide lines as stated below.
Method 1:
Soak the mesh into 40-50c lukewarm water that has been mixed with some detergent for 3 -5 minutes. Brush
the mesh softly as the texture is delicate and easily will damage.
Method 2:
The mesh also can be cleaned using dishwasher set with temperature at around 60 degrees.
Notice of cleaning cooker hood
• To protect the body of the cooker hood from deteriorate, is advisable to clean with hot water plus non-
corrosive detergent once every month if the cooker hood is used regularly.
• Please do not use abrasive detergent as it will damage the body of the cooker hood.
• The motor and other spare parts should keep in dry condition, as it will cause hazardous should there is
contact with water.
• Please switch off the cooker hood before cleaning.
• The carbon filter shouldn't be exposed to heat.
• Please do not open the fixed bar at the carbon filter.
• Should there is any faulty on the plug or the cord, please replace it with special soft cord.
Fault
Light on, but fan does
not work
Both light and fan do
not work
Serious Vibra-tion of
the unit
Suction per-formance
not good

Cleaning and Care

Troubleshooting

Cause
The fan blade is jammed.
The motor is damaged.
light bulb burn.
Power cord looses.
The fan blade is damaged.
The fan motor is not fixed
tightly.
The unit is not hung properly
on the bracket.
Too long distance between the
unit and the cooking plane
Solution
Switch of the unit and repair by qualified
service personnel only.
Replace the bulb with correct rating.
Plug in to the power supply again.
Switch of the unit and repair by qualified
service personnel only.
Take down the unit and check whether the
bracket is in proper location.
Readjust the distance to 65-75cm
16

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

10030822

Inhaltsverzeichnis