auna Worldwide Bedienungsanleitung Seite 25

first set the date then finally the time.
• Network: The unit is compatible to all standard network protocols and encryption methods, including
Wi-Fi Protected Setup (WPS). In case of an unencrypted network, the unit will automatically establish
connection and no further settings are necessary.
Standard encrypted network:
• To enter the network key (password), rotate the SELECT control to move the cursor through the
characters to be selected and press on it to confirm.
• The key that is entered will be displayed in the upper part of the display.
WPS-encrypted network
WPS-encrypted networks are identified by their network names as soon as the unit starts searching for
available network connection. Select one of the following connection methods:
• Push button: The radio prompts you to press the connection button on the router, it then scans
for a corresponding network and establishes the connection.
• Pin (code number): The radio generates an 8-digit code number. Enter this code number into the
wireless router or access device.
• WPS: Enter the network key for a standard encrypted network.
Note: Additional information on setting up the WPS-encrypted networks can be obtained in the user
manual of your WPS router.
Completion: The radio establishes connection with the selected network. If connection is failed, the
radio returns to the previous display and prompts you to retry. If an existing network connection is lost,
it would automatically attempt to retry for reconnection.
Several preset EQ modes are available: FLAT, CLASSIC, ROCK, POP, JAZZ
• View settings: You can check the following information on the currently connected network: Active
connection, MAC address, WLAN region, DHCP.SSID, IP address, subnet mask, gateway address first
and second DNS.
• WLAN region: Select a WLAN region for optimal WLAN connectivity: Most of Europe, USA, Canada,
Spain, France, Japan, Singapore, Australia, Republic of Korea.
• Manual settings: Select either a wireless or wired connection and activate/deactivate DHCP.
• Network profile: The radio stores the last four wireless networks that were connected and attempts
each time to reconnect to one of them. You can view a list of the registered networks. From here you
can delete unwanted networks by turning the SELECT control followed by pressing on it to confirm
delete.
Equaliser
Network
25
www.auna.de