auna Worldwide Bedienungsanleitung Seite 31

broadcast, press the INFObutton.
Scan settings: FM scan is defaulted to stop at any available station, this would result the poor reception
from weak stations. Ta change the scan settings to stop only at stations with good signal strength, press
the MENU button then enter into the „Scan setting" section and select YES by the use of the SELECT control.
Audio settings: The radio will automatically switch between FM stereo and mono reception, but you can
override this and switch this function manually which is helpful for poor signal reception. To select list ening
in mono, press the MENU butt an then enter into the „Audio setting" section and select YES by the use of
the SELECT control.
Note: During FM stereo reception , the received LIR stereosoundwill be automatically combined to one
single channel to suit the single speaker design of this radio.
AUX mode plays audio from an external audio source such as MP3 player. To play audio with Auxin mode:
• Decrease the volume level an both the radio and the audio source device.
• Connect the external audio source to the AUXIN (3.5mm) stereo socket.
• Either press MODE until the display shows „AUXin" or select „AUX in" in the main menu by the use of
the SELECT control.
• Set the desired volume an the radio and the external audio device if necessary.
Note: To further enhance energy saving, unit will go into standby mode after ab out 15 minutes from
Aux in mode if with out signal input.
m
There are two wake-up alarms with snooze function and one sleep function to turn the radio off after a set
period. Each alarm can be set to start in a particular mode. To set or change an alarm:
• Select either Alarm 1 or 2 in the main menu or press the ALARMbutton an the remote control.
• Select theAlarm number (1 or 2) and set the following parameters:
• Enable: Off, Daily, Once, Weekends, Week days
• Time:
• Mode: Buzzer, In ternet radio, DAB, FM
• Preset: Last listened or 1-10
• Volume: 0-32
• To activate the new settings, scroll down the menu using the SELECT control and select „Save". The
display will show the active alarms with an icon at the bottom left.
• The alarm will be triggered at the preset time. To temporarily silence it, press the SNOOZE button.
The Radio will switch to standby for the set period , and the silenced alarm icon flashes in the display.
Other Settings
AUX In
Alarm & Sleep Timer
31
www.auna.de