Bulb And Lamp Replacement; Troubleshooting - Klarstein 10029385 Bedienungsanleitung

Manual Clearing Mode for Cleaning Operation:
• In STANDBY MODE, press & hold ON/OFF for 3 seconds,(it must operate with the control panel on the
hood) window open automatically. When the window opening complete, display as STANDBY MODE.
• In MANUAL CLEARING MODE, press & hold ON/OFF for 3 seconds(it must operate with the control panel on the
hood), window close automatically. When the window closing complete, system comes back to STANDBY MODE.
Replacing Bulbs
1. Switch the unit off and unplug the appliance. Re-
move the lamp cover by unscrewing the 2 screws.
2. Unscrew the incandescent bulb. Replace with the
same type and rated bulb:
Incandescent Bulb E 14: max 40 W
Replacing Halogen & LED Lamps
1. Disconnect the light wiring point which is located within the
hood, (behind the grease filer).
2. Then use a screw driver remove the bulb holders and wiring
from the hood. Replace with the same type and rated lamp:
Halogen lamo: max 20 W
LED Lamp: max 1.5 W
Fault
Light on, but fan does
not work
Both light and fan do
not work
Serious Vibra-tion of
the unit

Bulb and Lamp Replacement

Troubleshooting

Cause
The fan blade is jammed.
The motor is damaged.
light bulb burn.
Power cord looses.
The fan blade is damaged.
The fan motor is not fixed
tightly.
The unit is not hung properly
on the bracket.
Solution
Switch of the unit and repair by qualified
service personnel only.
Replace the bulb with correct rating.
Plug in to the power supply again.
Switch of the unit and repair by qualified
service personnel only.
Take down the unit and check whether the
bracket is in proper location.
26