ZUMEX ANEXO Bedienungsanleitung Seite 20

TANK SUB-FILTER (51)
Place on the inside of the juice extraction container (Figure 5).
TANK/COOLER BUOY (52)
TANK MODEL
Line up the lugs of the buoy support with the larger diameter holes on the lid. Turn the support
and place it in its housing (Figure 16.1 and 16.2).
Insert the buoy and place the lid on the tank (Figure 16.3 and 16.4).
The BUOY unit can be detached as indicated in Figure 17 for cleaning.
COOLER or TANK MODEL
Slacken the upper lugs. Line up the plate with the openings from below. Tighten the upper
lugs again (Figure 19).
TANK (53)
Use the thread to secure the Self Service tap to the Tank container. Make sure that it is in
upright position (Figure 18.1).
TANK TAP (55)
Use the thread to secure the Self Service tap to the Tank container. Make sure that it is in upright
position (Figure 18.1).
The Tank tap can work continuously or discontinuously. Just turn the handle 180º and it will be
locked when the handle is lowered, thus permitting free spout.
For cleaning, you can remove the upper part of the Self Service tap (Figure 18.2).
LEVEL DETECTOR (56)
This component only needs to be manipulated if a spare part is requested. Remember to place the
detector in the same position as the original detector. If you have a Tank machine, the detector
is located in the upper part; if you have a Cooler machine, it is located in the lower part (Figure 5
and Figure 6).
COOLER UNIT (70)
Place the cooler unit in its housing in the stand (Figure 6).
Mount the components as indicated in Figure 19 in this order.
Mount the piston-gasket and the lever in the tank following the steps indicated in the
enclosed drawing.
Fit the tank.
Adjust the pump lid inside the tank with the arrow pointing towards you.
Secure the metal coupler plate, securing the tank with it.
SS/TANK STAND (90), COOLER STAND (100)
Machine placement on display stand:
IMPORTANT: This operation must be carried out by 2 or 3 people. It must never be attempted
by just one person.
Lock the front wheels of the stand with the brake pedal to prevent it from moving during the
installation.
After unpacking the stand, remove the screws from the fixing brackets and put them on one
side for later. See detail "A" of Figure 8.
The peel chutes and the drip tray of the stand with filter are located on the inside of the stand.
Place the machine on the stand, making the inside corners of the machine base coincide
with the two rubber blocks of the stand. Thus, the fixing bracket holes will coincide with
the machine holes. You can now secure the machine with the screws mentioned above (See
Figure 5 or 6).
Remember:
The machine and display stand are joined together with the screws supplied, as indicated in
this instructions manual.
Never try to tilt the machine or the stand. To move, unlock the wheels.
37