ZUMEX ANEXO Bedienungsanleitung Seite 19

PLASTIC JUICE CONTAINER (30)
Make sure that the sealing gasket is correctly mounted on the container (Figure 11). Then place
the container in the machine. Line up and place under the container on the four lugs that you will
see on the machine (Figure 2).
PLASTIC INNER FILTER (31)
Place on the inside of the juice extraction container (Figure 2).
PLASTIC JUICE FILTER (32)
Place on the inside of the juice extraction container (Figure 2).
SS JUICE CONTAINER (40)
Line up the container in the main opening. At the same time, line up the two side lugs at the ends
of the container and press. Pressing the side buttons may help mount it (Figure 12).
SS SUB-FILTER (41)
Place on the inside of the juice extraction container (Figure 3).
SS/TANK FILTER (42)
Line up the 2 rear openings with the 2 inner rear lugs of the container. Let the filter fall forwards
and line up the front openings with the front lugs.
The filter rests on the SS juice container (40) (Figure 3) or Tank juice container (59) (Figure 5).
PULP SWEEPER (43)
Make sure that the inner guide of the pulp sweeper is correctly mounted (Figure 13).
You can extract or insert the pulp sweeper by turning the side catch 90º (Figure 13).
Note: Make sure that the catch is in its closed position, so that the pulp sweeper can never
accidentally drop from the filter.
SELF SERVICE TRAY TAP (44)
To mount the Self Service tap in the container, line up the rear lug and screw the floating nut on
the rear of the tap (Figure 3).
TAP OPERATION
You can make the tap work normally by pressing and releasing it to extract the juice
(Figure 14.1).
You can lock/unlock the "free spout" or "discontinuous spout" function by leaving the catch
in position "a" (free position) or in either of the 2 positions "b" for locking the relative spout
(Figure 14.2).
You can anchor the button in "free spout" position. To this end, turn the ring with the dotted/
solid lines until the solid line coincides with the glass symbol.
Release the button. This will secure it.
To release it, just press the button again (Figure 14.1).
For daily cleaning, you can remove the upper part of the tap and the inlet spout (Figures 14.3
and 14.4).
DETECTOR TUBE GASKET (46)
If required, this gasket can be removed for cleaning (Figure 3 or 4).
MACHINE SUPPLEMENT (47)
Use this supplement to raise the machine (Figure 3).
Important! The machine must never be placed on the supplement by one single person.
TANK JUICE CONTAINER (50)
Line up the two side lugs at the ends of the container and press. Pressing the side buttons may
help mount it (Figure 15).
To remove the container, just press the side buttons and pull out towards you.
35