Heiniger CORDLESS Betriebsanleitung Seite 27

Animal Clipper Head
MALFUNCTION
Top blades move too little
Upper blade does not move
Pressure regulating screw
jams
There is play in the laminated
springs in the head anchorage
Driving carrier has too mutch play
between the laminated springs
Driving carrier can only be
moved up and a with difficulty
Cuts badly or not at all
Instruction manual CORDLESS
CAUSE
Crank drive block lost
(Illustration 1, Item 5)
Laminated springs completely
broken
Crank drive block and/or crank
spindle are worn out (inadequa-
te lubrication) (Illustr. 1, Item 5)
Faulty cogwheel
(Illustration 1, Item 13)
Thread is fouled or rusty
(Illustration 1, Item 10)
Pressure spring has jammed
Fixing screws loose
Laminated springs and/or
fixing-screws are worn out
Centring bush lost
Clipper blades are blunt
Clipper blades have not been
correctly ground
Clipper blades are not oiled
Clipping tension too low
Laminated springs are broken
The animals' hair is wet
Hairs jammed between upper
and lower blades
(Illustration 8, Items 1+2)
Too much play in clipper head
Spacing between upper and
lower clipper blades incorrect-
ly adjusted
RECTIFICATION
Replace crank drive block
Replace laminated springs on
both sides
Replace crank drive block
Have crank spindle replaced
Replace cogwheel
Clean and oil thread
Have pressure spring replaced
Tighten fixing screws
Have laminated springs and/or
fixing-screws replaced
Have new centring bush fitted
Have top and bottom blades
resharpened by service centre
Oil clipper blades every
15 minutes
(Illustration 7, Items 1+2+4)
Increase pressure by tightening
the pressure regulating screw
(Illustration 6)
Have laminated springs replaced
Only clip when dry
Disassemble blades, clean well
and oil; then refit and increase
pressure
Have clipper head inspected
Adjust spacing correctly
(Illustration 13)
13