PeakTech 5175 Bedienungsanleitung Seite 16

6. Performing Measurement
General:
1. Turn off the machine using the ON button (2).
2. Press the "FAST / SLOW" button (3) to switch the desired term
evaluation.
3. Press the "MAX / MIN" button (4) to switch to the maximum value
mode. The meter is now renewed only if the current measured
value exceeds the highest previous reading.
4. Press the "MAX / MIN" button (4) again to switch to the minimum
value mode. The meter is now renewed only if the current
measured value is less than the lowest previous reading
5. Press the button (4) again to switch back to the normal
measurement mode.
Automatic Power Off
If the device is not used, it automatically turns off after 10 minutes.
For continuous measurements, the automatic shutdown can be
disabled:
1. Turn off the unit (if necessary) with the ON button (2)
2. Turn on the unit again with the ON button (2) and hold the button
for about 5 seconds while the device starts
3. The system displays the
4. Release the ON button (2) and turn the power off again
5. The next time the device is switched on, the
the display
Backlight
This unit features an automatic backlight, which activates when
the light sensor on the front panel detects low light conditions.
symbol in the display for a second
-15-
icon appears in