Installation; Electrical Connection - IKEA MATMÄSSIG Bedienungsanleitung

ENGLISH
Problem
You can hear a constant
beep noise.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your IKEA store call centre. You can find a
full list of IKEA appointed contacts at the
end of this manual.

Installation

Warning! Refer to Safety
chapters.
General information
Installation process must follow
the laws, ordinances, directives
and standards (electrical safety
rules and regulations, proper
recycling in accordance with the
regulations, etc.) in force in the
country of use!

Electrical connection

Warning! Refer to Safety
chapters.
Warning! All electrical
connections must be made by an
authorised installer.
Electrical connection
• Before connecting, check if the nominal
voltage of the appliance, provided on
Possible cause
The electrical connection is
incorrect.
Important!
• For the minimum distances from the other
• If there is no oven beneath the hob insert
• Do not use silicon sealant between the
• Follow the connection diagram (it is
• Use only original spare parts provided
• The appliance is not provided with a
Disconnect the hob from the
electrical supply. Ensure a
correct installation by calling
an authorised installer.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
appliances or cabinets and further
information on the installation refer to
the Assembly Instruction.
a dividing panel at a minimum distance
of 20 mm from the bottom of the hob.
appliance and the worktop.
the rating plate, corresponds to the
available supply voltage. The rating
plate is located on the lower casing of
the hob.
located on the underneath surface of the
casing of the hob).
by spare parts service.
mains cable. Buy the right one from
16
Remedy