Troubleshooting - KLIPPO LAWNMASTER Bedienungsanleitung

Grass cutting faults
Problem
Ridge lines in the cut across the direc-
tion of travel.
Some uncut or poorly cut strands of
grass.
Lines of uncut or badly cut grass in
direction of travel.
Scalping.
Excessive bottom blade wear.
TROUBLE SHOOTING
Possible Cause
Forward speed too high.
Cylinder speed too slow.
Height of cut too low.
Cutting cylinder is partially out of con-
tact with the bottom blade.
Cutting cylinder is in heavy contact with
the bottom blade.
Height of cut is too high.
Cutting edges of cutting cylinder / bot-
tom blade are rounded.
Cylinder to tightly adjusted to bottom
blade causing damage on the knife.
Bottom blade in ground contact.
'Nose down' attitude of bottom blade.
Undulations too severe for height of cut
setting.
Undulations too severe for height of cut
setting.
Bottom blade in heavy ground contact.
Cutting edges of cutting cylinder / bot-
tom blade are rounded.
Cutting cylinder is in heavy contact with
the bottom blade.
Damaged cutting cylinder or bottom
blade.
38
Action
Reduce engine rpm.
Reduce forward speed.
Raise height of cut.
Re-adjust cutting cylinder to bottom
blade.
Re-adjust cutting cylinder to bottom
blade.
Lower height of cut.
Grind cutting edges.
Grind cutting edges.
Raise height of cut.
Re-adjust height of cut.
Raise height of cut.
Raise height of cut.
Raise height of cut.
Grind cutting edges.
Re-adjust cutting cylinder to bottom
blade.
Regrind or replace if necessary.