Troubleshooting - KLIPPO Pro 17 Bedienungsanleitung

AIR CLEANER SERVICE
(fig. 10) Briggs & Stratton Quattro engines.
Clean and lubricate the foam element every third month or
every 25th working hour, which occurs first. NB. Clean the
element more frequently if the working conditions for the
engine are dusty.
1. Screw off the screw and demount the air cleaner
carefully so that dust don't fall down into the carburator.
2. Take the air cleaner apart and clean all parts. Clean the
foam in liquid cleaning and water. Press it dry in a clean
shread. Appease with engine oil. Press with a clean
shread to take away all unnecessary oil.
3. Assemble all the parts again and mount the air cleaner
properly on the carburator with the screw.
AIR CLEANER SERVICE
(fig. 11) Honda GCV 135-engines
Clean the element every three months or every twenty-five
hours, whichever comes first. NB. Clean the element more
frequently when operating under dusty conditions.
1. Loosen the snap-on fastenings and lower the cover as
shown in the figure.
2. Carefully remove the element.
3. Clean the element by carefully knocking it against a
flat surface. If it is heavilly soiled, it must be replaced.
4. Replace the element, close the cover and push the
snap-on fastenings properly.
NORMAL OIL CHANGE
Unscrew the dipstick and place the lawn-mower in such a
position as to allow the oil to run out. This can be done
most easily when the engine is warm and the fuel tank is
empty. Then fill with fresh oil (0,6 l SAE 30)up to the
FULL-mark on the dipstick (fig. 8).

TROUBLESHOOTING

If the engine does not start, check the following:
1. That there is fresh and new petrol in the tank and the
petrol valve is open (Honda engines).
2. Check that the choke is correctly adjusted (Honda
engines).
3. Control that the brake cable is correctly adjusted.
4. That the spark plug is not fouled with soot and the gap
is correct (it should be 0,7-0,8 mm). If the engine fails
to start after these measures, contact your nearest ser-
vice workshop.
5. Does the cutting result being bad and the blades of the
grass being uneven in the cut area? Change the blade
of the lawnmower!
CLEANING
Place the lawnmower with the spark plug upwards. First
run until the tank is empty, otherwise petrol will leak out
through the venting hole in the tank cap. Beware of the
environment and the fire danger! NB. Never flush the
lawnmower with a high-pressure cleaner.
WINTER STORAGE
Run until no more petrol is left and change the oil.Then
pour one spoonful of oil into the spark-plug hole and turn
over the engine so that the oil is distributed. Clean the air
filter and gear housing. Store the lawnmower indoors in a
dry spot. Charge the battery with the charger.
19