Technical Data; Intended Use - EINHELL 11012 Originalbetriebsanleitung

Anleitung_GH_BC_30_AS_SPK7:_
GB
Open-ended spanner 8/10 mm
Allen key 4 mm
Allen key 5 mm
Pull hook
Handle screw M6
Nut M6
Washer Ø 6mm
Guard hood for cutting line/cutting blade
Original operating instructions
Safety information

4. Intended use

The power scythe (using the cutting blade) is
designed for cutting young trees, strong weeds and
undergrowth.
The power trimmer (using the line spool with cutting
line) is designed for cutting lawns, grassed areas and
small weeds. The operating instructions as supplied
by the manufacturer must be kept and referred to in
order to ensure that the equipment is properly used
and maintained. Any use which is not expressly
permitted in the manual may result in damage to the
equipment and place the user in serious danger. Be
sure to observe the restrictions in the safety
instructions.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
Important. Due to the high risk of bodily injury to the
user, the petrol power scythe must not be used to
carry out the following work: to clean dirt and debris
off walkways, or to chop up tree or hedge clippings.
Moreover, the petrol power scythe may not be used
to level out high areas such as molehills. For safety
reasons, the petrol power scythe may not be used as
a drive unit for other work tools or toolkits of any kind.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
20
12.03.2013 10:26 Uhr

5. Technical data

Engine type
Engine power (max.)
Displacement
Idle speed of engine
Max. engine speed
Scythe:
Trimmer:
Max. cutting speed
Scythe:
Trimmer:
Ignition
Drive
Weight (with empty tank)
Cutting line diameter (HYP, PA Ø 410)
Cutting circle diameter
of blade (HYP, 65 Mn Ø 230-4T)
Cutting line length
Cutting line diameter:
Tank capacity
Spark plug
Sound and vibration
Sound and vibration values were measured in
accordance with EN ISO 11806-1; EN ISO 22868;
EN ISO 22867.
Sound pressure level L
Uncertainty K
Sound power level L
Uncertainty K
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Functions
Vibration emission value a h = 7 m/s
K uncertainty = 1.5 m/s
Seite 20
2-stroke engine, air-cooled, chrome cylinder
3,000 ± 200 min
Centrifugal clutch
Champion RCJ6Y
pA
pA
WA
WA
2
2
0.8 kW (1.1 HP)
30,3 ccm
-1
-1
8,500 min
-1
7,400 min
-1
6,375 min
-1
5,550 min
Electronic
6.7 kg
41 cm
23 cm
8 m
2.0 mm
0.8 l
93,2 dB(A)
1,5 dB
110 dB(A)
1,5 dB