Kärcher RC 3.000 Originalbetriebsanleitung Seite 27

Indicator lamp displays:
Green Permanent light
Blinks slowly
Fast flashing
Red Fast flashing
Blinks slowly
Red Permanent light
Problem
Cleaning robot does not find its
way out of niches between pieces
of furniture
Gently rising furniture
Cleaning robot got stuck under-
neath items of furniture
Loose objects have been taken up
by the brush roller and are now
blocking the brush
Cleaning robot comes to a halt af-
ter charging/vacuuming process
Cleaning robot runs unevenly on
carpets, bobs up and down
Cleaning robot only runs in star-
shaped pattern
Cleaning robot cannot find the sta-
tion
Cleaning robot does not dock onto
the station
Cleaning robot has absorbed wet
dirt
Troubleshooting
Normal operating state
Cleaning robot is searching for the station
Batteries are charged
Cleaning robot is stuck
Cleaning robot is dirty
Contact authorised Customer Service!
Display Consequence
Red Cleaning robot comes to a
Fast halt.
Red Cleaning robot gets stuck
Fast and stops
Red Cleaning robot comes to a
Fast halt.
Red Cleaning robot comes to a
Slowly halt.
Red Dirt receptacle is full
Slowly
Red Brush roller is too dirty
Slowly
Red Brush roller is blocked
Slowly
Red Brush roller has not been
Slowly inserted correctly
Red Suction outlet of the station
Slowly is clogged
Green Uneven cleaning
Permanent
light
Green Only a specific area/loca-
Permanent tion is cleaned
light
Green Station is place in an unfa-
Slowly vourable location in the
room
Green Cleaning robot is not vacu-
Slowly umed
– The brush roller and the flat
filter in the cleaning robot
are glued
– 14
EN
Remedy
Move furniture if necessary.
Switch the cleaning robot off and re-
move it from in between the furni-
ture.
Place it back on the floor and switch
it on.
Turn off the cleaning robot and re-
move it from the object on which it
got stuck.
Place it back on the floor and switch
it on.
Switch the cleaning robot off and re-
lease it.
Place it back on the floor and switch
it on.
Switch the cleaning robot off and
turn it around.
Carefully remove the blocking ob-
jects; loose objects include: Toys,
clothes, ...
Empty and clean the dirt receptacle.
Clean the brush roller.
Carefully remove blocking objects
from the brush roller.
Check the seat of the brush roller.
Check the suction outlet of the sta-
tion and clean it, if necessary.
This is normal on deep-piled car-
pets > 20 mm.
Clean the dust sensors using a soft
cloth or a soft paintbrush.
Reposition the station, observe in-
stallation instructions.
Check the seating of the cover of
the dirt receptacle.
Place the station on a level surface.
Install the access ramp of the sta-
tion.
Remove the brush roller and the flat
filter and clean them thoroughly.
Caution: Do not install a wet filter.
27