Maintenance And Care - Kärcher RC 3.000 Originalbetriebsanleitung

Selecting the cleaning duration
Select the cleaning duration on the station using the fol-
lowing table. (Basic setting: continuous operation).
Illustration
 Press the "Select cleaning duration" button until the
desired cleaning duration is set.
Note: The indicator lamps indicate the selected
cleaning duration.
Selecting the cleaning duration
Press once Cleaning duration 3 hours
for rooms smaller than 45 m
Press twice Cleaning duration 6 hours
for rooms between 45 and 90 m
Press three times Cleaning duration 9 hours
for rooms between 80 and 135 m
Press four times back to continuous operation (basic
setting)
The cleaning process will start. If the selected cleaning
duration has elapsed, the cleaning robot is emptied and
charged and then comes to a standstill in front of the
station.
Ideal for cleaning runs during the night or if you are at
home.
Illustration
 Press the "Quiet mode" button.
The indicator lamp lights up. The station empties
the cleaning robot, works for 8 hours with a re-
duced noise level and a reduced performance.
Then, the station returns to normal operation.
Operating Programs
The cleaning robot provides of four operating pro-
grammes that allow him to automatically adjust to the
various degrees of dirt accumulation on the floor. The
dirtier the floor, the more extensive the cleaning per-
formed by the robot.
The selection of the operating programme is automati-
cally controlled by sensors located in the dirt receptacle.
The selection is made according to the detected degree
of dirt accumulation. This selection is made automati-
cally and is not displayed.
If the degree of dirt accumulation has been reduced, the
1st operating programme is selected again.
Operating Programmes of the cleaning robot
1 Normal cleaning
Robot runs according to the random method at
normal speed.
2 Individual spot with normal degree of contamina-
tion
Robot slowly moves across the dirty area.
3 Individual, more contaminated spot
Robot slowly runs forward/backwards across the
dirty area.
4 Extensive, very dirty area
Robot runs slowly and radially across the dirty
area describing a star.
24
Quiet mode
If the cleaning robot should terminate its work after the
subsequent charging process:
Illustration
 Press the "Parking the cleaning robot" button.
The indicator lamp lights up.
Note: After its next return to the station, the clean-
ing robot is emptied and charged. Then, the robot
is turned off and comes to a standstill in front of the
station.
Terminate operation / switch off
2
If you want the cleaning robot to immediately interrupt
the cleaning, i.e., if you want to move the appliance to a
2
different location:
2
Illustration
 Switch off the cleaning robot.
 Then, switch off the station.
Note:
If you do not want to use the cleaning robot for a longer
period of time, allow the batteries to charge completely
(see Chapter "Start-up").
DANGER
Turn off the station and the cleaning robot before per-
forming any maintenance work!
Exchanging the filter bag of the station
The filter bag needs to be replaced when the red indica-
tor lamp - filter full - is illuminated.
Illustration
 Open the filter cover.
Illustration
 Pull the filterbag upwards by the flap to remove it
from its holder. Place the filter bag into the ordinary
refuse for disposal.
Spare filter bag kit: (5 filter bags, 1 motor protec-
tion filter)
Order number: 6.904-257.0
Illustration
 Push the new filter bag all the way into the holder.
Caution: Never operate the appliance without a fil-
ter bag!
 Close the filter cover.
– 11
EN
Parking the cleaning robot

Maintenance and care

Station for cleaning robot