Kawasaki 603.010.060 Originalbetriebsanleitung Seite 40

blade stops before removing the workpiece.
GB
Maintenance and Cleaning
Service
Warning: Preventive maintenance performed
by unauthorized personnel may result in
misplacing of internal wires and components
which could cause serious hazard. We
recommend that all tool service be performed by
a Factory Service Center or Authorized Service
Station.
Cleaning
Warning: To avoid accidents, always disconnect
the tool from the power supply before cleaning
or performing any maintenance. The tool may be
cleaned most effectively with compressed
air. Always wear safety goggles when cleaning
tools with compressed air.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through openings.
Check regularly to make sure the lower guard
and all moving parts are working properly.
Remove accumulated sawdust from working
parts by blowing with compressed air or wiping
with a damp cloth.
Caution: Certain cleaning agents and solvents
damage plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated
cleaning solvents, ammonia and household
detergents that contain ammonia.
Care of Blades
Blades become dull even from cutting regular
lumber.
If you find yourself forcing the saw forward to
cut instead of just guiding it through the cut,
chances are the blade is dull or coated with wood
pitch.
When cleaning gum and wood pitch from
blade, unplug the saw and remove the blade.
Remember, blades are designed to cut, so handle
carefully. Wipe the blade with kerosene or similar
solvent to remove the gum and pitch. Unless
you are experienced in sharpening blades, we
recommend you do not try.
Tool lubrication
Your tool has been properly lubricated and is
ready to use. It is recommended that tools with
gears be regreased with a special gear lubricant
at every brush change.
Periodically lubricate moving parts with a
silicone, or light oil spray. Do not use grease
because it tends to attract and hold sawdust.
CAUTION. Do not use powerful cleaning agents
to clean the plastic parts of the tool.A mild
detergent on a damp cloth is recommended.
Water must never come into contact with the
tool.
Carbon Brushes
The brushes and commutator in your tool have
been engineered for many hours of dependable
service.
To maintain peak efficiency of the motor, we
recommend every two to six months the brushes
be examined.
Only genuine replacement brushes
specially designed for your tool should be used.
Motor Brush Replacement
To inspect or replace brushes:
1. Unplug the saw.
Warning: The brush cap is spring loaded by
the brush assembly.
2. Remove the brush cap on the motor using a
wide flat blade screwdriver.
3. Pull out the brush (B12). Repeat for the
opposite side.
NOTE: If installing the existing brush or brushes,
make sure the brush goes in the same way it
came out. Otherwise a break-in period will occur
that will reduce motor performance and increase
brush wear.
4. Inspect brushes for wear. On the wide flat side
of brush is a wear limit line. If the brush contact
face is at or beyond (no line visible) the limit
replace brushes as a set.
40