Kawasaki 603.010.060 Originalbetriebsanleitung Seite 29

13. Do not overreach
- Keep proper footing and balance at all times.
14. Maintain tool with care
- Keep cutting tools sharp and clean for better
and safer performance. Follow instructions for
lubrication and changing accessories. Inspect
tool cord periodically and if damaged have it
repaired by an authorized service facility. Inspect
extension cords periodically and replace. If
damage. Keep handles dry, clean and free from
oil and grease.
15. Disconnect tools
- When not in use, before servicing and when
changing accessories such as blades. Bits and
cutters.
16. Remove adjusting keys and wrenches
- Form the habit of checking to see that keys and
adjusting wrenches are removed from the tool
before turning it on.
17. Avoid uninten tional starting
- Do not carry a plugged-in tool with a finger on
the switch Ensure switch is off when plugging in.
18. Use outdoor extension leads
- when tool is used outdoors,use only extension
cords intended for outdoor use.
19. Stay alert
- Watch what you are doing Use common
sense,Do not operate tool when you are tired.
20. Check damaged parts
- Before further use of the tool,a guard or
other part that is damaged should be carefully
checked to detemine that it will operate properly
and perform its intended function.Check for
alignment of moving parts,free running of
moving parts,breakage of parts,mounting and
any other conditions that may affect its operation
Aguard or opther part that is damaged should be
properly repaired or replaced by an authorized
service center unless otherwise indicared in
this instruction manual.Have defective switches
replaced by an authorized service facility Do not
use the tool id the switch does not turn it on and
off.
21. Warning
- the use of any accessory or attachment,other
than those recommended in this instruction
manual,.may present a risk of personal injury.
22. Have yout tool repaired by a qualified
person
- This electric tool is in accordance with
therelevant safety requirements Repairs shouls
only be carried out by qualified persons using
original spare parts,otherwise this may result in
considerable danger to the user.
Electrical safety
• Handle the cord carefully. Never use the cord to
carry the tool or to pull the plug from an outlet.
Keep the cord away from heat, oil, sharp edges
or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk
of electric shock.
WARNING: this mitre saw is for indoor use only.
do not expose it to rain or use in damp locations.
Service
• Tool service must be performed only by qualified
repair personnel. Service or maintenance
performed by unqualified personnel could result
in a risk of injury.
• When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual. Use
of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of
electric shock or injury.
Additional safety rules for mitre saws
• Do not use saw blades which are damaged or
deformed;
• Replace the table insert when wron;
• Do not use saw blades of high-alloy high-speed
steel (HSS).
• Do not use saw blades with characteristics
which do not comply with those specified in
these instructions for Use. And the blades must
29
GB