Bench Mounting - Kawasaki 603.010.060 Originalbetriebsanleitung

arm, pull on the release knob (6), rotate it 45°
and let go, slowly raise the saw arm.
WARNING. Do not lift the saw while holding on
to the guards.Use the carrying handle (8).
Transportation
Lift the mitre saw only when the saw arm is
locked in the down position, the saw is switched
off and the plug is removed from the power
point.
Only lift the saw by the carrying handle (8) or
outer castings.Do not lift the saw using the
guard or operating handle (7).

Bench mounting

The saw base has holes in each corner to facilitate
bench mounting.
1)Mount the saw to a level,horizontal bench or
work table and fix the saw to the bench using
4 bolts (not supplied).
2) If desired, you can mount the saw to a piece of
13 mm or thicker plywood which can be clamped
to your work support or moved to
other job sites and re-clamped.
CAUTION. Make sure that the mounting surface
is not warped as an uneven surface can cause
binding and inaccurate sawing.
Adjusting the three position switch handle
The switch handle can be positioned in any of
three different orientations, depending on the
cutting situation and user preference.
• Horizontal
• 45° Left
• 45° Right
To reposition the main handle:
1. Release handle clamp (B4).
2. Pull and hold handle rotation release button
(B4).
3. Rotate handle to desired location.
4. Let go over release button to set handle into
place. Release button will retract down only in
one of the three (3) positions.
Note: Power switch can not be actuated unless
release button is retracted down. Do not attempt
to switch tool on between handle position,
damage may occur.
5. Lock the handle clamp.
Adjusting the three-position handle clamp
tension
1. Open handle clamp.
2. Using screwdriver, increase tension by turning
both set screws 1/4 turn to the left, tighten by
turning to the right. Always adjust both set
screws by the same amount.
3. Close handle clamp.
4. Check the tension.
Stabilizer bar
When the saw is not fitted to a bench, always fit
the stabilizer bar (39) into the holes at the rear
of the saw base.The stabilizer helps prevent
the saw from tipping backwards when the slide
action is used.
Release knob
The release knob (6) is provided for holding the
cutting head down while transporting or storing
the mitre saw.The saw must never be used with
the release knob locking the head down.
Slide lock
When tightened, the slide lock (29) prevents
the saw head from sliding.Tighten the slide lock
during transportation.
Mitre table lock (B10)
The mitre table lock (25 ) is used to lock the table
at the desiredmitre angle.
The mitre saw cuts from 0° to 45° both left and
right.To adjust the mitre angle loosen the mitre
table lock (25), push the locking button (25A)
and using the mitre table handle adjust the
mitre angle to the desired position.The mitre
table features positive click stops at 0°, 15°, 22.5°,
31.6° and 45° for quick setting of common mitre
angles.
WARNING. Be sure to tighten the mitre table
lock (25) before making a cut.Failure to do so
33
GB