Kawasaki 603.010.060 Originalbetriebsanleitung Seite 32

direction of rotation of the blade or cutter only.
GB
WEAR GOGGLES
WEAR EARMUFFS
WEAR A BREATHING MASK
WARNING! For your own safety read instruction
manual before operating mitre saw. Wear eye
protection. Keep hands out of path of saw blade.
Do not operate saw without guards in place.
Do not perform any operation freehand. Never
reach around saw blade. Turn off tool and wait
for saw blade to stop before moving workpiece
or changing settings. When changing the blade,
replace and secure all guarding to its original
position and correctly before starting tool.
Disconnect power (unplug tool) before changing
blade or servicing. Do not expose to rain or use
in damp locations. To reduce the risk of injury,
return carriage to the full rear position after each
crosscut operation.
The tool must be used only for its prescribed
purpose. Any use other than those mentioned in
this Manual will be considered a case of misuse.
The user and not the manufacturer shall be
liable for any damage or injury resulting from
such cases of misuse.
The manufacturer shall not be liable for any
changes made to the tool nor for any damage
resulting from such changes.
Even when the tool is used as prescribed it is not
possible to eliminate all residual risk factors. The
following hazards may arise in connection with
the tool's construction and design:
• Damage to the lungs if an effective dust mask is
not worn.
• Damage to hearing if effective earmuffs are not
worn.
Extension cords
• Replace damaged cords immediately. Use of
damaged cords can shock, burn or electrocute.
• If an extension cord is necessary, a cord with
adequate size conductors should be used to
prevent excessive voltage drop, loss of power
or overheating. Always use EU listed extension
cords
OPERATING INSTRUCTIONS
Accessories
The tool is supplied with the following
accessories:
.
Saw blade (fitted)
.
Workpiece clamp
.
Saw blade flange wrench
.
2 Side bars
.
Stabilizer Bar
.
Dust bag
We recommend that you purchase your
accessories in the store from where you obtained
the tool.Use good quality accessories from the
brand recommended by the vendor.Sales staff
will help and offer advice.
Unpacking
Due to modern mass production techniques, it
is unlikely that your Power Tool is faulty or that
a part is missing. If you find anything wrong,do
not operate the tool until the parts have been
replaced or the fault has been rectified. Failure to
do so could result in serious personal injury.
1) Remove all loose parts from the carton.
2) Remove the packing materials from around
the saw.
3) Using the carrying handle (8) carefully lift the
saw from the carton and place it on a level
work surface.
4) The saw has been shipped with the saw arm
locked in the down position.To release the
saw arm, push down on the top of the saw
32