Illustration
Pull out the safety sheet.
Close the safety filter sack using the
self-adhesive flap.
Pull the safety filter sack towards the
rear.
Illustration
Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
Illustration
Securely close the safety filter bag with
the attached cable tie.
Remove the safety filter bag.
Wipe the inside of the container using a
damp cloth.
Dispose of the safety filter bag in a dust-
tight bag according to the statutory pro-
visions.
Insert and lock the suction head.
General
Warning
The flat pleated filter must always be in
place while vacuuming.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After completion of the wet vacuuming:
–
Dry the flat folded filter. Clean the elec-
trodes using a brush. Clean the contain-
er with a damp rag and dry it.
Rotating knob
Appliance OFF
Appliance ON
22
Turning on the Appliance
Plug in the main plug.
Switch on the appliance at the rotating
knob.
Cleaning operations
Perform the cleaning operation.
Turn off the appliance
Switch off the appliance at the rotating
knob.
Pull out the mains plug.
After each operation
Empty the container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
While vacuuming the appliance, use at
least one vacuum cleaner of the same
or higher classification.
Rinse out the accessory parts with wa-
ter if necessary and dry them.
Fold the push handle in/out
Loosen the fastening screws of the
pushing handle and adjust the pushing
handle.
Storing the Appliance
Illustration
Store the suction hose and the mains
cable as shown in the illustration.
Place the appliance in a dry room and
secure it from unauthorized use.
– 5
EN