Auerswald COMfortel WS-R2 Inbetriebnahmeanleitung Seite 25

Protect the device against dirt, excessive dust, condensation,
caustic liquids, and steam.
Mark holes on the wall where you intend to mount the device.
1.
Important: Make sure there are no electrical leads, or gas or
water pipes, in the area in which you want to drill the holes.
Drill the holes (diameter 6 mm) and insert the dowels into
2.
them.
Screw in the screws far enough that the screw head is about
3.
5 mm away from the wall.
Hang the device on the screws and move it downwards on
4.
the wall until it hangs securely.
Note: Ensure the screws do not touch the circuit board.
COMfortel WS-R2/WS-R4 - Setup Guide V03 02/2015
Preparation
25