Functional Description - Bosch PMF 180 E Multi Originalbetriebsanleitung

OBJ_BUCH-345-006.book Page 15 Wednesday, May 12, 2010 12:48 PM
Do not treat the surface to be worked with
solvent-containing fluids. Materials being
warmed up by the scraping can cause toxic
vapours to develop.
Exercise extreme caution when handling
the scraper. The accessory is very sharp;
danger of injury.
Products sold in GB only: Your product is
fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the origi-
nal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should nev-
er be inserted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a
residual current device (RCD) with a rated
residual current of 30 mA or less.

Functional Description

Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or
serious injury.
Intended Use
The machine is intended for sawing and cutting
wooden materials, plastic, gypsum, non-ferrous
metals and fastening elements (e.g., unhard-
ened nails, staples). It is also suitable for work-
ing soft wall tiles, as well as for dry sanding and
scraping of small surfaces. It is especially suita-
ble for working close to edges and for flush cut-
ting. Operate the power tool exclusively with
Bosch accessories.
Bosch Power Tools
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 On/Off switch
2 Thumbwheel for orbit frequency preselection
3 Vacuum connection
4 Vacuum hose*
5 Handle (insulated gripping surface)
6 Venting slots
7 Tool holder
8 Plunge saw blade
9 Clamping bolt with washer
10 Allen key
11 Sanding plate
12 Sanding sheet
13 Segment saw blade
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Technical Data
Multi-function tool
Article number
Preselection of orbital
stroke rate
Rated power input
Output power
No-load speed n min
0
Oscillation angle,
left/right
Weight according
to EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate
of your machine. The trade names of the individual
machines may vary.
2 609 004 835 | (12.5.10)
English | 15
PMF 180 E
3 603 A00 0..
W 180
W 74
-1
15000–21000
° 1.4
kg 1.2
/II