Shimano E6000 series Gebrauchsanweisung Seite 26

<Switch to walk assist mode>
1. Press assist-Z to switch the mode to "OFF".
2. Press assist-Z once again 2 seconds until "WALK" is
displayed.
3. Press and hold assist-Z to start walk assist.
<Walk assist mode operation>
When "WALK" is displayed, press and hold down
Assist-Z on the assist switch to start the walk assist
function. Releasing Assist-Z stops the walk assist
function, or pressing Assist-Y can stop the walk assist
function.
• If Assist-Z is not operated for over 1 minute, the mode will change to OFF.
• If the bicycle does not move after the walk assist function turns on, the function automatically stops. To restart the walk assist function,
release the assist switch and press and hold down Assist-Z again.
• The walk assist function can operate at a maximum of 6 km/h.
• The assistance level and speed vary with the gear position.
Assist
2 seconds
Assist
Press
and
hold
down
21
Shift
< SC-E6000 >
< SC-E6010 >
Shift