Troubleshooting - Stylies ATLAS Gebrauchsanweisung

•
Store the device in a dry place and beyond the reach of children (in its box).
•
Do not switch on the device when there is no water in the Reservoir.
•
Do not use metal or hard object to clean the Oscillator.
•
Do not use any harsh chemicals in the water Reservoir.
•
Do not put the device into water, or let water get into the Main Base.
•
To avoid damages due to escaping water, the unit may not be placed on the floor.
•
Do not touch the Oscillator during operation.
•
Never submerge the unit with electrical system and air vent in water or other liquids or rinse
it off with water or other liquids.
•
Do not use the device in an area where the humidity level exceeds 60 percent.
•
Never tilt, move, or attempt to empty the device while it is operating.
CLEANING PROCEDURE
Your Travel Humidifier is a reliable and robust product, its good performance however require regu-
lar maintenance. The frequency of maintenance depends on how and how often you use it.
Depending on the water hardness, you may find calcium and magnesium scales or other contamina-
tions left in the Reservoir covering the surface of the Oscillator. therefore , you need to clean and to
descale your Atlas regularly, depending on the operating time.
To avoid lime scales
•
Use clean and softened water, cold boiled water, or distilled water.
•
Clean the Reservoir, especially the surface of the Oscillator weekly: do NOT use any sharp tool
or instruments.
•
Dry the unit completely with clean soft cloth after your use and before storage.
Descaling and Cleaning
•
Switch off the unit by turning the Main Switch (6) to the very left side of the dial and disconnect
the Adaptor from main supply.
•
Clean the bottle, the Bottle Adapter, Mist Outlet. Remove scales and residual dirt by de-calci-
fication agent.
•
The surface of Oscilliator can be cleaned with the Brush (12).
Note: this product is NOT dishwasher save
•
Rinse all the parts with fresh clean water. Note: be careful not to let water running into the
Base Unit.
•
Dry all parts with soft cloth.
IMPORTANT:
Do not use cleaning agents or other scouring agents to clean the unit.
Do not use any metal or hard objects to clean the Oscillator.
TROUBLE-SHOOTING
Problem
Unit switched on, but
no mist coming out
Possible Cause
Adaptor not properly con-
nected with the unit and the
main supply
Solution
Check if the Adaptors Plug is
properly inserted into main
supply socket and with the
Adaptor socket on the Main
Base
9