Schaub Lorenz IN3FZ Bedienungsanleitung Seite 37

A(mm) B(mm) C(mm) D
760
B. Before the installation
The worktop must be square and plane and made of heat-resisting material.
Structural elements should not interfere with the installation area.
The installation must meet the safety requirements as well as the legal rules and
regulations.
When the socket is not accessible for the user or a fixed electrical connection
of the appliance is required, an all-pole disconnecting device must be
incorporated during installation. Disconnecting devices are switches with a
contact opening distance of at least 3 mm. These include LS-switches, fuses and
protectors (EN 30335). Read the information on the nameplate and the
connection diagram before connecting the appliance to the mains. The
electricity supply must be performed via a 16A automatic cut-out. If in doubt,
always contact the local building authorities and consult the relevant legal
provisions.
The wall surrounding the hob should be covered with heat-resistant material,
e.g. ceramic tiles.
C. After the installation
The power cable must not come into contact with cabinet doors or drawers.
The appliance must be supplied with an adequate flow of fresh air from outside
the cabinet to the base of the hob.
The circuit breaker must be easily accessible.
D. Before locating the fixing brackets
50 min. 20 min. Air inlet Air outlet 5 mm
37
E