Operating Instructions - Leister FUSION 2 Bedienungsanleitung

Operating Instructions

GB
Please read operating instructions carefully before
use and keep for further reference.
Leister FUSION 2 / 3C / 3
Hand extrusion welder
Application
Welding PE and PP thermoplastics for applications in
• container engineering
• plastic fabrication
10
• pipeline construction
• landfill sites and abandoned polluted areas
Warning
DANGER!
Danger when opening up the tool, as live components and connections are
exposed. Therefore, before opening it, unplug the tool to ensure disconnection
from the mains. Electronically conductive material (eg PE-EL) must not be welded.
Incorrect use of the hand extruder (eg overheating of the material) can present a
fire and explosion hazard, especially near combustible materials and explosive
gases.
Danger – can cause burns! Do not touch bare metal parts and emerging
material while hot. Allow the device to cool. Do not direct stream of hot air or
emerging material towards people or animals.
Caution
The voltage rating stated on the tool must correspond to the mains voltage.
120
If power failure occurs, the hot air blower switch and drive must be switched off
230
(release locking device).
For personal protection on building sites we strongly recommend the tool be
FI
connected to a RCCB (Residual Current Circuit Breaker) .
The tool must be operated under supervision. Heat can ignite flammable
materials which are not in view.The machine may only be used by qualified
specialists or under their supervision. Children are not authorized to use this
machine.
Protect tool from damp and wet.
(Translation of the original operating instructions)