Safety Instructions; Unpack - IKA HB 10 Betriebsanleitung

For your protection
• Read the operating instructions in full be-
fore starting up and follow the safety in-
structions.
• Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• Wear your personal protective equipment in accordance with
the hazard category of the medium to be processed. Otherwi-
se there is a risk of splashing liquids.
• When emptying the device use only the recessed handles to
carry and hold it.
• Set up the device in a spacious area on an even, stable, clean,
non-slip, dry and fi reproof surface.
• Prior to each use, always check the device and accessories for
damage. Do not use damaged components.
• Caution! Only process and heat up media that has a fl ash
point higher than the adjusted safe temperature limit of the
heating bath that has been set.
The safe temperature limit of the heating bath must always
be set to at least 25 °C lower than the fi re point of the media
used.
• Danger of being burnt! When in operation the
upper corner of the bath can heat up to 180 °C.
• Prior to fi lling or emptying the heating bath, the device must
be switched off and disconnected from the power supply at
the plug.
• Only fi ll or empty the heating bath when it is cold.
• Empty the heating bath prior to transporting it.
• Never operate the heating bath without tempering medium.
• Unpacking
- Please unpack the device carefully
- In the case of any damage a fact report must be set imme-
diately (post, rail or forwarder)

Safety instructions

• Caution! The preferred tempering medium in the heating bath
is water (up to approx. 80 °C). Low viscosity silicone oils (50
mPas) with a fl ashpoint > 260 °C are also permitted.
There is a risk of burning when using tempering media with
lower fl ashpoints!
• When using as a water bath, the use of demineralised water
is recommended.
• Always observe the minimum fill level of one litre when using
oil as the tempering medium.
• Ensure that the IR interface is not soiled.
• Beware of hazards due to flammable materials.
• Only process media that will not react dangerously to the ex-
tra energy produced through processing. This also applies to
any extra energy produced in other ways, e.g. through light
irradiation.
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• Refer to the operating instructions for the accessories.
• Safe operation is only guaranteed with the accessories descri-
bed in the "Accessories" chapter.
• Use the HB 10.2 cover or the HB 10.1 spray guard.
• Always disconnect the plug before fitting accessories.
• The appliance does not start up again automatically following
a cut in the power supply.
• The device is only disconnected from the power supply net-
work if the device power switch is off or the plug is pulled out.
• The socket for the mains cord must be easily accessible.
For protection of the equipment
• The voltage stated on the type plate must correspond to the
mains voltage.
• Socket must be earthed (protective ground contact).
• Protect the appliance and accessories from bumps and impacts.
• The appliance may only be opened by experts.
Unpacking
• Delivery scope
Heating bath IKA
- Heating bath
- Mains cable
- Operating instructions
HB 10
®
11