Observe Ambient Temperature; Connecting The Appliance - Siemens KI26F Serie Gebrauchsanleitung

en
Observe ambient
temperature!
Depending on the climatic class" (see
rating plate), the appliance can be
operated at the following ambient
temperatures:
(The rating plate is situated in the bottom
left hand side of the appliance.)
Climatic class
Ambient temperature
from...to
+10 °C to 32 °C
SN
+16 °C to 32 °C
N
+18 °C to 38 °C
ST
+18 °C to 43 °C
T
If the upper ambient temperature is
exceeded, the cool fresh" compartment
may become too warm.
Note:
At room temperatures below 20 °C the
interior light may come on at a reduced
luminosity when the door is almost closed
(or when the light switch is depressed).
This is quite normal and can be ignored.
Ventilation
The air on the rear panel of the appliance
heats up. The warm air must be able
to escape. Otherwise, the refrigerator
must work harder. This will increase the
power consumption. Therefore:
Never cover or block ventilation openings!
18
Connecting the
appliance
After installing the appliance, wait at least
½ hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be easily accessible.
Connect the appliance to 220 240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is located in the
refrigerator compartment at the
bottom left hand side. The mains
connection cable may be replaced
by an electrician only.
Warning!
!
Never connect the appliance to
electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).