Technical Specifications - urmet domus 1706 Installationsanleitung

Vorschau ausblenden Andere Handbücher für 1706:

Benutzerhandbuch (16 Seiten)

Inhalt

Seite von 16

/ 16
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

FUNCTION

FLOOR CALL FUNCTION

The indoor station is equipped with a pair of terminals (CP) for connecting the ﬂ oor call button. The indoor

station will ring with the set tone for 3s when the button is pressed. Connect this button to indoor station 0

only if there are several indoor stations in parallel. Indoor stations 0 and 1 will ring immediately. Stations 2

and 3 will ring immediately after.

ADDITIONAL RINGER MANAGEMENT

The indoor station is equipped with a pair of terminals (S-, S+) for connecting a supplementary ringer or a

relay. This ringer is controlled when any call tone is generated.

MASTER DOOR UNIT OPEN DOOR FUNCTION

The video door phones can monitor physical state of the 'Master' door by connecting a sensor to the SP/GND

terminals. A red icon

will appear on the side of the display when the door is open.

For instructions on:

• Direct functions: door lock, audio, mute, staircase light, auto-on, switchboard calls, indicating LED.

• Menu functions: audio and video adjustments, call tone selection and adjustment, video door phone

answering service, keypad light colour selection, intercom calls, etc.

Refer to the speciﬁ c instruction manual attached to the product and which must be given to the end user.

FLUSH-MOUNTING BOX FASTENING PROCEDURE

At the end of the programming procedure, fasten the video door phone to the ﬂ ush-mounting body by means

of the four screws provided.

Clip the frontal panel onto the support.

Fit the front panel on the support by applying pressure to the entire surface. All the fastening tabs of

the front panel must be fastened. Check that the front panel surface is aligned with the surface of the

buttons at the end of the assembly procedure.

Remove the protective ﬁ lm.