Eaton Powerware 9125 Installationsanleitung Seite 10

Installation
6
7. Verify that the AS/400 and other equipment to be protected by
the UPS is powered off.
8. Connect one of the supplied communication cables to the UPS
communication port according to your computer system:
For the AS/400.
S
The "AS/400" end of the cable connects to the port marked
"J14" or "UPS"on the AS/400 rear panel.
For the RS/6000.
S
software, use the supplied RS/6000 communication cable.
For PCs and workstations.
S
supplied with the power management software CD.
9. Plug your equipment into the appropriate UPS output
receptacles using the equipment power cords supplied with the
UPS.
NOTE If you are using the Load Segment feature, see the Powerware 9125 User's
Guide for more information on controlling and assigning the load segments.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
10. Turn on the equipment that is connected to the UPS.
11. Plug the power cord from the UPS into a power outlet.
For 230V models (including P11 and P16)
power cord to connect the UPS to the power outlet.
All front panel indicators flash briefly and the UPS conducts a
self-test.
When the self-test is complete, the
indicating the UPS is in Standby mode with the equipment
offline.
Powerware 9125 Installation Guide for IBM Applications
®
Use the supplied AS/400 communication cable.
If you are installing power management
Use the communication cable
. Use the AS/400 or RS/6000
µ
i ndicator flashes,
05146789 A Uncontrolled Copy
S