Operation Without The Remote Control Unit; Care And Cleaning; Air Filter - Axair ulisse 13 A Bedienungsanweisungen

OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION BUTTON to select the desired mode:
• COOL or HEAT for heat pump models
• COOL for cooling only models
EG
NOTE
The air conditioner will start in automatic fan speed
and flap sweep operation. The temperature setting is
22°C for cooling mode and 26°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the
OPERATION BUTTON until the OPERATION lamp is turned
off.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.

CARE AND CLEANING

CAUTION
For safety, be sure to turn the air conditioner off and
also to disconnect the power before cleaning.
OUTDOOR UNIT
(CASING AND CONDENSING COIL)
Some metal edges and the
G
condenser fins are sharp and may
cause injury if handled improperly;
special care should be taken when
you clean these parts.
Periodically check the outdoor unit
G
to see if the air outlet or air intake
are clogged up with dirt or soot.
The condenser
G
components of the outdoor unit must
be cleaned periodically.
Consult your DEALER or AFTER
SALES SERVICE.
INDOOR UNIT
Do not pour water on the unit to clean it. This will damage
G
the internal components and cause an electric shock
hazard.
Never use solvents, or chemical agents when cleaning the
G
indoor unit. Do not wipe the plastic casing using very hot
water.
Casing and Grille
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth. If these
parts are stained, use a clean cloth moistened with a mild
liquid detergent. When cleaning the grille, be careful not
to force the blades out of place.
OPERATION BUTTON
and other

AIR FILTER

The air filter must be cheked at least once every two weeks
operation. Operation with a dirty filter always causes a lower
efficency of the air conditioner and severe product damage.
The filter is located at the back of the intake grille in the front
of the air-conditioner and shall be removed from the upper
side of the unit.
HOW TO REMOVE THE FILTER
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
TRANSPORT
Preferably keep the air conditioner in the vertical position
during transportation. If this is not possible, then lay it on
one side; when at destination put the air conditioner back in
the vertical position and wait at least 10 minutes before using
it for cooling.
STORAGE
If you are not going to use the air-conditioner for a long period,
clean the air filters, evacuate the condensate from the indoor
unit through the drain hose at the unit back side. Do not
disconnect the flexible tube, unless you are obliged to do it:
in that case protect the open halves of the couplings with the
plugs supplied as accessories, that must be tightened with
a spanner. Do not put heavy objects on the top of the unit,
and protect it with a cloth or a plastic bag.
CONDENSATE DRAIN PIPE
11