Control Panel; Before Using The Appliance - Axair GAM 9 Bedienungsanleitung

CONTROL PANEL

A. ON/OFF Push-button switch
B. Cooling / Dehumidification push-button
C. High / Low fan speed push-button
D. Electronic thermostat Knob
E. Cooling lamp
F. High fan speed lamp
EG
G. Low fan speed lamp
H. Light up lamp for dehumidification.
Blinking lamp for full water tank.
I. Timer

BEFORE USING THE APPLIANCE

Check that the power supply at the location where the air conditioner is going to be
G
used is 220-240V ~ 50Hz .
Make sure that the electrical installation is suitable to supply continuously current
G
necessary for the air conditioner in addition to that already used by other electric
appliances (white goods, lighting). See the max electric input indicated on the
name plate positioned on the air conditioner.
The installation of a double-pole switch, protected by 10 A fuses of the delayed
G
type, upstream the electricity wall socket, is recommended.
The unit has to be connected according to the local electrical rules.
G
Make sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a
G
start-up current of 20 A (generally less then 1 second).
Do not install the air conditioner where it could be wetted by drops of water (i.e. in
G
laundries).
Make sure that the ON - OFF push-button switch on the control panel of the air
G
conditioner is in OFF position.
Before connecting the air conditioner to a power socket, make sure that the socket
G
is provided with an earth connection in compliance with local codes.
Never use the power plug as a mean to start or stop the air conditioner: always
G
use the ON/OFF push-button switch on the air conditioner control panel.
Do not move the air conditioner during operation, turn it off and disconnect the
G
plug from the power supply. Verify and eventually discharge the condensate water,
through the discharge tube located on the rear of the unit.
WARNING! Do not stick anything into the air outlet of the air conditioner. This is very dangerous because the fan is rotating
G
at high speed.
WARNING!
G
The air conditioner is provided with a time-guard system, which does not allow re-starting of compressor until after 3 min-
utes from a previous stop. So avoid quick movements of the thermostat knob in both directions when compressor is run-
ning.
Make sure that there are no obstacles around the unit affecting the free circulation of air. Do not block the air intake and
G
outlet of the unit with curtains or other. Never put objects on the top of the unit.
The air conditioner reaches the maximum efficiency at the following conditions:
G
1-The flexible tube is retracted, without bends and without the outlet nozzle.
2-When you switch on the air conditioner for the first time, set the fan at the LOW speed for at least one hour, then set the
HIGH speed.
The manufacturer assumes no responsibilities if the safety regulations or local codes are not observed.
G
WARNING
1. Always unplug the unit from the power socket before moving or cleaning it.
3
All manuals and user guides at all-guides.com
I A D C B
H
E
F
G