Installation - Omnitronic ADI-002P Bedienungsanleitung

(9) GND (Ground terminal)
Connect the ground lead of the turntable with this terminal to reduce humming and pop noise.
(10) DIGITAL INPUT
Connect your digital audio device here.
(11) USB-OUTPUT
The audio data, digitized in the ADI-200P, is sent to your computer via this USB port. It also acts as
power supply for the unit.
(12) DIGITAL OUTPUT
The music signal of this socket is digital. Connect the output to the respective input of a digital amplifier
for example.
(13) USB LINE-OUTPUT
The computer's digitized signal is routed to these RCA output sockets for connecting your recording
device or amplifier.
(14) LINE-OUTPUT
The ADI-200P's amplified signal is routed to these RCA output sockets for connecting your recording
device or amplifier.
(15) LINE-INPUT
RCA-sockets. Connect your line sources like CD, MP3, MD, DAT, Tape Decks with the LINE input-
sockets. Make sure that the PHONO/LINE is set to LINE.
(16) PHONO-INPUT
RCA-sockets. Plug in your turntable with magnetic cartridges requiring RIAA equalisation and
preamplification. Make sure that the PHONO/LINE is set to PHONO. For non-RIAA turntables plug into
the LINE input instead.
(17) AC/DC CONNECTION
Connect the connection cable of the power-unit with this socket.

INSTALLATION

(1) Connect your turntable, tape deck, CD player or other analog devices to the RCA input sockets of the
ADI-002P. Connect your digital audio device to the S/PDIF input socket of the ADI-002P.
If your turntable is equipped with a separat ground lead, connect it to ADI-002P's terminal to reduce
humming and pop noise. (Not neccessary for turntables with digital output).
Set the PHONO/LINE button according to the analog signal source. Activate the highpassfilter to cut
down unwanted low frequencies or noise of the turntable.
(2) Connect the ADI-002P to your computer via the USB port.
For recording, the ADI-002P does not require an additional sound card or driver installation and is
directly compatible with Win98SE/WinME/Win2000/WinXP and Apple OS9.1/OS.10/OSX.
(3) Determine the type of power supply.
Connect the connection cable of the power unit to the AC/DC IN-socket. Plug the power unit into your
outlet.
When connected to the USB port of your PC or MAC via USB cable, the ADI-002P takes its power
directly from the USB port and no external power supply is needed.
9 10
11 12 13 14 15 16
12/14
17
10359820_V_1_0.DOC