Description; Features; Overview - Omnitronic ADI-002P Bedienungsanleitung

DESCRIPTION

Features

USB Phono-PreAmp/Computer Interface for digital recording from line and phono sources
• Convert your old beloved analog files through USB into digital files on your PC in high fidelity quality
• No additional sound card or driver installation required for recording, direct compatibility with
Win98SE/WinME/Win2000/WinXP
• 16 bit / 44.1 or 48 kHz AD/DA converter
• Stereo input for turntables
• Separate line input for connecting tape decks, MD and DVD players, musical instruments or other analog
sources
• Switchable low pass filter
• Input signal adjustable via Gain control
• 3.5 mm line/headphones output with level control
• Stable 44.1 kHz S/PDIF digital output via RCA
• Power supply via USB or via supplied 9 V power unit
• Compatible with almost any recording software for MAC and PC

Overview

(1) PHONO / LINE-BUTTON
Set the PHONO/LINE-button according to the analog signal source.
(2) LOW CUT-SELECTOR
This switch activates the highpassfilter and allows you to cut down unwanted low frequencies. Please
keep this button pressed if you do not need these extremely low frequencies at any rate.
(3) GAIN-CONTROL
Used to set the level of the input signal. Reduce GAIN, if the CLIP LED lights up red.
(4) CLIP/SIGNAL-METER
This LED conveniently lets you know that the ADI-200P's hardware is working. If the unit is connected
correctly and is receiving an audio signal, the LED lights green. If the LED lights red, the signal level is
too high, causing overamplification. In this case reduce GAIN.
(5) MONITOR-SWITCH
Used to determine the output signal of the Monitor output. Set the switch to the left for the ADI-200P, set
it to the right for your PC or set it to the middle for both signals.
(6) USB MONITOR OUTPUT
Stereo 3.5 mm jack. Plug in your headphones or your local DJ monitor amplifier system here.
(7) MONITOR LEVEL-CONTROL
With the MONITOR LEVEL-Control, you can adjust the level of the signal to the stereo monitor ouput.
(8) POWER SWITCH
Press this button to start operating.
1 2 3 4 5 6
11/14
7 8
10359820_V_1_0.DOC