6.12 Long Term Storage - Jacobsen ROPS Bedienungsanleitung

6 OPERATION

6.12 LONG TERM STORAGE ____________________________________________________

General
1. Wash the unit thoroughly and lubricate. Repair and
paint damaged or exposed metal.
2. Inspect the unit, tighten all hardware, and replace worn
or damaged components.
3. Drain and refill radiator.
4. Clean the tires thoroughly and store the unit so the
load is off the tires. If unit is not on jack stands, check
tires at regular intervals and reinflate as necessary.
5. Keep the machine and all its accessories clean, dry
and protected from the elements during storage. Never
store equipment near an open flame or spark which
could ignite fuel or fuel vapors.
Battery
1. Remove, clean and store battery in upright position on a
non-conductive surface (wood) in a cool, dry place. To
prevent accelerated discharge, do not store battery on
concrete or steel surface.
2. Check and recharge battery every 60 to 90 days while
in storage.
3. Store batteries in a cool, dry place. To reduce the self
discharge rate, room temperature should not be above
80°F (27°C) or fall below 20°F (-7°C) to prevent
electrolyte from freezing.
Engine
1. While the engine is warm, remove drain plug, drain the
oil from the crankcase, and change oil filter. Install drain
plug and refill with fresh oil. Torque drain plug to 22 ft.
lb. (30 Nm).
2. Clean exterior of engine. Paint exposed metal or apply
a light coat of rust preventative oil.
3. Add a fuel conditioner or biocide to prevent gelling or
bacterial growth in fuel. See your local fuel supplier.
en-20
Attachments
1. Wash the attachments thoroughly, then repair and paint
any damaged or exposed metal.
2. Lubricate all fittings and friction points.
After Storage
1. Check and reinstall battery.
2. Check or service fuel filter and air cleaner.
3. Check the radiator coolant level.
4. Check oil level in the engine crankcase and hydraulic
system.
5. Fill the fuel tank with fresh fuel. Bleed the fuel system.
6. Make certain that the tires are properly inflated.
7. Start and operate the engine at 1/2 throttle. Allow
enough time for the engine to become properly
warmed and lubricated.
!
WARNING
Never operate the engine without proper ventilation;
exhaust fumes can be fatal when inhaled.