Operating Procedures - Jacobsen ROPS Bedienungsanleitung

6 OPERATION
6.3

OPERATING PROCEDURES_________________________________________________

A Roll Over Protection Structure (ROPS) is included with this groomer. Seat belts must be worn whenever operating
a groomer with a ROPS. Always keep seat belt snugly adjusted. DO NOT use seat belts on a groomer without a
ROPS.
If the groomer is overturning, hold onto the steering wheel. Do not attempt to jump out or leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection. Long hair,
loose clothing, or jewelry may get tangled in moving parts
1. Under no circumstances should the engine be
started without the operator seated on the unit.
2. Never run the engine in an enclosed area.
3. Keep hands and feet away from moving parts. If
possible, do not make adjustments with the engine
running.
4. Do not operate unit or attachments with loose,
damaged, or missing components. Replace all worn
or damaged decals
5. Operate and rake in a flat test area to become
thoroughly familiar with the operation of the unit,
controls and rake.
6. Study the area to determine the best and safest
operating procedure. Consider the height and angle
of the bunker and whether it is wet or dry. Each
condition will require
precautions. Enter and exit bunkers cautiously at
the lowest and flattest area.
7. Be aware of attachment discharge direction and
never direct discharge
bystanders, nor allow anyone near the machine
while in operation.
responsible for injuries inflicted to bystanders and/or
damage to their property.
!
CAUTION
Before operating, pick up all debris such as rocks,
toys, and wire which can be thrown by the machine.
Enter a new area cautiously. Always operate at
speeds that allow you to have complete control of the
unit.
8. Slow down and raise the attachments when
crossing paths or roadways. Look out for traffic.
en-14
!
WARNING
!
CAUTION
certain adjustments
of material toward
The owner/operator
9. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
Before you clean, adjust, or repair this equipment,
always disengage all drives, lower implements to the
ground, engage parking brake, stop engine, and
remove key from ignition switch to prevent injuries.
10. Operate engine at full throttle. Control speed by
using the forward/reverse pedals rather than the
engine throttle.
11. Slow down and use caution
12. Slow down and use extra care on hillsides. Read
or
Section 6.7. Use caution when operating near drop
offs.
13. Look behind and down before backing up to be sure
the path is clear. Use care when approaching blind
corners, shrubs, trees, or other objects that may
obscure vision.
is
Note: Never operate in reverse with rake down.
Rake may fold under unit and damage rake and unit.
14. Never use your hands to clean attachments, use a
brush. Attachments may have extremely sharp
edges that can cause serious injuries
!
WARNING