Attachments; Towing / Trailering - Jacobsen ROPS Bedienungsanleitung

6 OPERATION
6.8

ATTACHMENTS ___________________________________________________________

The Groom Master will accept several attachments
designed to perform a variety of operations. Before
installing and using attachments read and save the
instruction sheet included with it.
6.9

TOWING / TRAILERING _____________________________________________________

If the unit experiences problems and removed from the
area, it should be loaded onto a trailer for transport. If a
trailer is not available, the unit can be towed slowly short
distances.
Use care when loading and unloading unit. Fasten unit to
trailer to prevent it from rolling or shifting during transport.
Before towing, open tow valve. The tow valve permits
moving the unit without starting the engine and prevents
possible damage to hydraulic components.
The tow valve (A) is located on the hydraulic drive pump
under rear hood. To open valve, insert a pin into the small
hole in the valve stem. Turn the valve counterclockwise
one full turn.
Before towing make sure attachments are raised. If they
cannot be raised, remove them from the unit.
Close valve completely after towing.
NOTE: Do not exceed 1 MPH (1.6 KPH) while towing.
Long distance towing is not recommended.
en-18
Contact your Jacobsen Distributor for a complete list of
attachments and accessories available for your machine.
f
A
TRG004
Figure 6J