Werbung
GB - Problems and solution
Problem
Transmitter and Quadcopter cannot be binded
Transmitter led blinks
LCD transmitter is not showing the setting interface after
hold down the joystick for 1 second
Gyro not working well
Unable to Flip because to less flip power
Quadcopter shaking with noise
Switching between low and high rates on the transmitter is not
very user friendly.
Can not take off
The leg of the Quadcopter is easy taken apart
32
Solution
Throttle position need to be minimized to zero.
Replace new AAA batteries
Throttle not in zero position
Battery voltage lower
Re-binding
Land on to the ground for 3 seconds and take off again.
Electronic is overheated – Cooling down for at least 1 hour.
Press the cyclic joystick one time to enter into the expert(flip)
mode.
In the expert(flip) mode, the sensitivity on each channel should
be above 90%.
Please check if the canopy, chassis and rotors transformed or the
chassis not firmly joint with canopy.
Switch from expert mode to normal mode
Wrong installation on rotors, Rotors mark with A,B.please check.
Wrong installation on motors,please check if each motor installed
in correct position. See picture
This is a special design to absorb the impact from hard crash,
Force the leg back to the joint position by hand as picture shows.
Werbung
