Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2. Statutory Notification about the Battery Regulations
The delivery of many devices includes batteries, which for example serve to operate the remote
control. There also could be batteries or accumulators built into the device itself. In connection with the
sale of these batteries or accumulators, we are obliged under the Battery Regulations to notify our
customers of the following:
Please dispose of old batteries at a council collection point or return them to a local shop at no cost.
The disposal in domestic refuse is strictly forbidden according to the Battery Regulations. You can
return used batteries obtained from us at no charge at the address on the last side in this manual or by
posting with sufficient stamps.
You can obtain further information about the Battery Regulations from the Bundesministerium für
Umwelt, Naturschutz und Reaktorsicherheit (Federal Ministry of Environment, Nature Conservation
and Reactor Safety).
7.3. Replacing the fuse
1.
Switch off the clamp meter and disconnect all test leads from the inputs of the device and
the measurement circuit.
2.
Loosen the screw in the battery compartment cover with a screwdriver and remove the
battery compartment cover.
3.
Remove the blown fuse from the fuse holder FF500mA / 660V - and replace it with a new
fuse.
4.
Place the battery cover and secure it with the screw.
WARNING!
Do not operate your meter until the back cover is in place and fully closed.
Batteries, which contain harmful substances, are marked with the
symbol of a crossed-out waste bin, similar to the illustration shown
left. Under the waste bin symbol is the chemical symbol for the
harmful substance, e.g. „Cd" for cadmium, „Pb" stands for lead and
„Hg" for mercury.
-45-
Werbung
