Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.3.2. Direct Current Measurements up to 5000µA
Warning! Do not apply voltage directly across the terminals. The device must only be connected in
series with the circuit to be measured.
To perform current measurements interrupt circuit to be measured and connect test leads to two
connection points. Never connect test leads parallel across a voltage source. This can blow the fuse
and damage the circuit under test.
Note: The maximum input current is 5000 uA. If you exceed the maximum permissible value, blow the
fuse (500mA / 660V) and must be replaced.
1. Turn the Function selector switch to µA position.
Plug the black test lead to the COM-input and the red test lead to the
2.
3. Select the desired AC or DC range by pressing MODE-button.
4. Connect the test leads in series with the measuring circuit and read the measured value on the
LCD display.
-38-
V//CAP/µA input.
Werbung
