Connecting The Headset - comfortel 1100 Inbetriebnahme- Und Kurzbedienungsanleitung

Preparation

Connecting the Headset

Requirements
– A wired headset corresponding to technical data listed on
– To connect a COMfortel headset from Auerswald: An adapter
Note: The adapter is available at specialised stores as an Auerswald
accessory.
Steps to Take
1.
Remove the receiver plug from the corresponding jack on the underside of
the telephone.
2.
Insert the headset plug in the jack labelled with
telephone (see
3.
Guide the cable to the outside through one of the cable channels.
Further Steps
In order to make calls over the headset, headset operation must be enabled
after commissioning.
28
Fig. 6 below).
Fig. 6: Connecting a COMfortel headset
Page 24.
on the underside of the