Packaging; Commissioning, Operation - Tecsis P3297 Betriebsanleitung

5.Trasport, packaging and storage / 6.Commissioning, operation

5.2 Packaging

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in
installation site, sending for repair).
Ensure that the pressure connection thread and the connection contacts will not be damaged.
GB
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: -20 ... +80 °C
„
Humidity: 45 ... 75 % relative humidity (no condensation)
„
WARNING!
Before storing the instrument (following operation), remove any residual media.
This is of particular importance if the medium is hazardous to health, e.g.
caustic, toxic, carcinogenic, radioactive, etc.

6. Commissioning, operation

Required tools: wrench (flats 27), screw driver
32
CAUTION!
Pay attention to any liquid leaking out, for this points to a diaphragm
„
damage.
Use the pressure sensor only if the diaphragm is undamaged.
„
Use the pressure sensor only if it is in a faultless condition as far as the
„
safety-relevant features are concerned.
tecsis Operating Instructions - Pressure sensor P3297